SmallBot
reconn's
reconn's
world
world
.com



Email Statistics | May 29, 2016
Schematics Depot >> Audio >> sound detector latch

sound detector latch:


parts:
U1NE555 timer IC
R11k resistor
R250k potentiometer
C10.1uF ceramic capacitor
C210uf tantalum capacitor

all resistors are 5 or 10 percent tolerance, 1/4-watt
all capacitors are 10 percent tolerance,
rated 35 volts or higher
for use with the sound detector circuit/electret mike amplifier. when the 555 ic goes into timing mode (triggered by an output signal from the sound detector amplifier,) the timer's output (pin 3) is set into HIGH for a duration set by C2, and R2. adjusting R1 will adjust how long it listens, from 10 seconds all the way down to 2/10ths of a second. this could be used to listen for hand claps.
Return to: Schematics Depot, or Audio Circuits


Site by Andrew Wilson. Copyright 1997-2006 All Rights Reserved unless otherwise noted.
Schematics in Schematics Depot were found on the internet and assumed to be in public domain. Contact webmaster if the copyright holder wants them pulled for any reason.